Hi,
I am about to program a 24C16 serial eeprom, which is located inside an internal circut. I do have access to SCL and SDA. Is this possible to program "In-circut" with the Labtool 48 UXP programmer? I also have access to a DataMan S4.
Or do I need a special programmer for this programming via SDA, SCL?
Thanks in advance.
Addisen
Serial "In-circut" - programming
-
- Posts: 931
- Joined: 10 Nov 2011 09:51
Re: Serial "In-circut" - programming
Hi Addisen,
I would not recommend using the D48UXP in that way, we do however have a programmer that has a dedicated ISP port built in. The Dataman 40Pro supports the Microchip 24C16A & B versions via the ISP connector. The connection details are as shown in the picture. Full product details can be found on our website.
Neil
Dataman (Neil Parker) attached the following image(s):
Image1.jpg
Image2.jpg
I would not recommend using the D48UXP in that way, we do however have a programmer that has a dedicated ISP port built in. The Dataman 40Pro supports the Microchip 24C16A & B versions via the ISP connector. The connection details are as shown in the picture. Full product details can be found on our website.
Neil
Dataman (Neil Parker) attached the following image(s):
Image1.jpg
Image2.jpg
Return to “Dataman 48, 48LV, 48XP and 48UXP”
Who is online
Users browsing this forum: No registered users and 17 guests