Hello Neil, My target device is the AT24C16A EEPROM. Looking at the connection details, I have all connected to the target board except Pins 3,7,13,14,15,16,19,and 20. Pin 5 was connected to the target board as well as grounded. I hope this connections are right. With the target system powered at 3....

Hi Neil, I have been experiencing some challenges in getting the EEPROM Programmed. I am a bit new to this. For the ISP connector, is it necessary I make Pins 2,4,6,8,10,12,17 & 18 all connected to GND, or I just need connect one of them to ground ? I also need to know how to set the parameters ...

Hi Neil,

Thanks for the reply.

I want to program the AT24C16A EEPROM however, I have been looking at the Software for a while now and can not find where to select the ISP mode for the device.

Thanks

I need to write some constant into my EEPROM (I2C) on my board using the dataman-48PRO programmer which has the ISP connector. Are there any manual and instructions to guide me through? I need to know how to set it up as well as using the Dataman pro desktop application.

Paul. A