Hello, According to device notes an MCS file is recommended for programming this device. I wasn't able to create MCS file from .bit file using Xilinx Impact software as I get error. But I was able to create a stpl file using the svf file from the same project the .bit file was created from. So in ot...

Hello,
I read that the 48Pro2 has ISP but what that means to me is not well understood. I would like to be able to connect this programmer to a handler and have it program devices as well as bin them out as passes or fails. Is that possible?

Hello, I loaded an JEDEC programming file on our 48Pro2 and get an error "CHECKSUM error: file CRC = 0000 buffer CRC = 779D" When I look at the file their is no checksum 779D mentioned but their are two places at the last two lines of the file that have 0000. Other JEDEC files I've looked ...

Thank you!

Hello,
Is it possible to perform calibration in-house on the 48Pro2 programmer?

Rgs,

Thank you Neil, I have subscribed to the forum that lets me know about any new software updates.

Rgs,

I was using our 48Pro2 to programming some FPGA's and successfully had over 60 programmed when the software locked up and error box popped up stating USB driver version error (V:3.42.0000 E:3.24.0.x). I found a newer version of the PG4UW software on this website and after installing it everything se...

Thank you Neil, that worked perfectly

Hello everyone, I am a new user of Dataman 48Pro2 and figuring out how the software works. I will be creating Jobs and saving in protected mode for our operations department to run product against them for program/erase/blank check operations. We require a summary and the Job Report has all the deta...