Hello ZaheerAhmad, Thank you for the information and log files showing actions with the device and the result of the Selftest… . I can see that this device when used on the Dataman-40Pro requires an extra adaptor: 1.png Can you confirm that you have both the DIL8/DIL8 SEE-1 and DIL8/SOIC8 ZIF 150mil...

Hello ZaheerAhmad, Thank you for posing in our user forum. We implemented the programming algorithm for the M45PE10 over 10 year ago and have not modified it since. We have had no reports of complaints from customers about the support. Can you try upgrading the software to the latest version v3.88/1...

Hello, We do support the Sandisk/M-Systems MDOC H3 chip on the Dataman-48Pro2C and above models. However, the support is paid, because we spent a lot of time on the support for these chips (more than 6 man-months of development time). The cost for access to the support on top of the price of the pro...

Dear Dirk, Thank you for posing in our user forum. First step is to run the Selftest... from the Programmer menu using the supplied 40pin diagnostic pod. This will test the programmers internal hardware. I can see the following information for the the Xicor X2404 device in the "device info"...

Hello Martin,

I have fixed the link above.

Best regards,

Neil Parker
Dataman Programmers

Hello underwurlde, The pinout details of the S4 emulation cable can be found under the S4 resources section of our website: https://www.dataman.com/dataman-s4-resources Here is the direct link to the document: https://www.dataman.com/mwdownloads/download/link/id/154/ If you have any further question...

Hello Davemartin, The Intel E28F800B5B device is a pretty straightforward FLASH memory device. I would not expect any issues programming it unless there was a problem with the programmers hardware or the device itself was suspect. Can you run the Selftest... from the programmer menu using the suppli...

Hello shagster1974, Unfortunately not. The 26C505 is CMOS based whereas the 16F505 is FLASH based and requires a different programming algorithm. In order to program the PIC16F505 device you would need to purchase a new programmer model such as the Dataman-40Pro or the more capable, Dataman-48Pro2 ....

Hello lundal1403, Below are the Dataman-48 upgrade paths showing which versions of the programmers can be upgraded to the latest UXP version and also how to identify the different versions. A. D-48 ( Firmware Version 1.9 ) *(1) cannot be upgraded to D-48UXP. B. D-48/LV ( Firmware Version 2.0 and Abo...

Hello Victor, The calibration test is just that, a thorough test to make sure the voltages generated by the programmer hardware are within the necessary ranges. If any of the measured values were outside those ranges, then the calibration would have failed and the programmer would need to be returne...