40PRO and TIBPAL16L8-15CN

Topics related to the Dataman 40Pro
Guest
Posts: 723
Joined: 09 Nov 2011 17:16

40PRO and TIBPAL16L8-15CN

Postby Guest » 10 Nov 2011 16:18

Hi Neil

I have the 40PRO now (I upgraded from the S4) and trying to erase/program the TIBPAL16L8-15CN

the problem is i cannot find a device within the PAL16L8 range that the programmer will let me read it let alone erase it

the TIBPAL16L8-15CN is a Texas device and its data sheet is here
http://focus.ti.com/lit/ds/symlink/tibpal16l8-15c.pdf

the data sheet does say its functional equivalent, but faster than a PAL16L8A


I also have a PAL16R4BCN i cannot find a workable setting for. I am still trying to find a datasheet online for this IC
manufacturer: MMI

can you help? Is there a workable solution i could use?

I am using the software v2.75/12.2010 version
many thanks
Andrew

Dataman (Neil Parker)
Posts: 931
Joined: 10 Nov 2011 09:51

Re: 40PRO and TIBPAL16L8-15CN

Postby Dataman (Neil Parker) » 10 Nov 2011 16:18

Hello Andrew,

The TIBPAL16L8-15CN and PAL16R4BCN devices are only supported on the Dataman48Pro+ and Pro2 range of single site and gang programmers. The Dataman-40Pro hardware is not able to program chips with a high current requirement, specifically bipolar based chips (PROM, PLD, etc.)

In order to program the TIBPAL16L8-15CN and similar devices you will need to upgrade your programmer.

Details of the D48Pro+ and Pro2 programmers can be found on our website www.dataman.com

If you have any questions, please contact me.

Regards,

Neil Parker
Dataman Programmers

Guest
Posts: 723
Joined: 09 Nov 2011 17:16

Re: 40PRO and TIBPAL16L8-15CN

Postby Guest » 10 Nov 2011 16:18

Cheers, many thanks Neil

As i have just recently upgraded from the S4 to the 40Pro, i just dont have the justification or the money to upgrade yet again for another programmer.

thanks for the reply
Andrew


Return to “Dataman 40Pro”

Who is online

Users browsing this forum: No registered users and 4 guests