Dataman Forum

Hi,
did anyone program the C505A with Dataman48?
I always get "overcurrent error" when programming starts. Blank checking works.
Adapter and chip are ok.

Thanks!

Carsten

Hello Carston,

Without knowing the full part number of your device it is difficult to help. The D48 supports only the SABC505CA device. There are a number of other devices in this family all with slightly different algorithms and requirements so I would not expect one algorithm to successfully program a different device.

For a greater range of support for these Infineon C505A devices I would recommend looking at the Dataman-48Pro2 which currently supports the following devices from this family:

Infineon SAB-C505A-4E
Infineon SAF-C505A-4E
Infineon SAH-C505A-4E
Infineon SAK-C505A-4E

Further details of the Dataman-48Pro2 Universal Programmer can be found on our website here.

Best regards,

Neil Parker
Dataman Programmers