Im wanting to program an Altera MAX II EPM1270F256C5N CPLD using the ISP.
The JTAG connector in the device I have is a 10 pin header. How does the 48pro2's 20 pin ISP connector convert over this this device?
Thanks
JonT
Altera EPM1270F
Altera EPM1270F
Last edited by Guest on 10 Nov 2011 16:00, edited 1 time in total.
-
Dataman (Neil Parker)
- Posts: 931
- Joined: 10 Nov 2011 09:51
Re: Altera EPM1270F
Hello JonT,
All information relating to the pin outs of the Dataman-48Pro2 programmers ISP port can be found in the control software. With the correct device selected in the software simply hit (CTRL + F1) and click on the "ISP Connection Details" tab where you will be presented with a numbered diagram of the ISP port and a schematic showing our recommendation for connecting to the target device.
If you do not find the information that you are looking for, please let me know.
Regards,
Neil Parker
Dataman Programmers
All information relating to the pin outs of the Dataman-48Pro2 programmers ISP port can be found in the control software. With the correct device selected in the software simply hit (CTRL + F1) and click on the "ISP Connection Details" tab where you will be presented with a numbered diagram of the ISP port and a schematic showing our recommendation for connecting to the target device.
If you do not find the information that you are looking for, please let me know.
Regards,
Neil Parker
Dataman Programmers
Who is online
Users browsing this forum: No registered users and 8 guests
