Dataman Forum

Hello,
Is it possible to perform calibration in-house on the 48Pro2 programmer?

Rgs,

Hello IntegraUser,

If you suspect there is a problem with your programmer you can run the Selftest... routine from the Programmer menu using the supplied diagnostic pod type-II which will perform a test of all the pindrivers and other internal programmer hardware and will reveal most hardware problems with the programmer.

For the calibration test the programmer should be returned to our US or UK offices. Details of the calibration service can be seen on our website here https://www.dataman.com/dataman-calibration-service

Best regards,

Neil Parker
Dataman Programmers

Thank you!