New to the S3. TI 77c82
Posted: 10 Nov 2011 15:47
Hi all
I'm new to the S3 via an inherited project. I need to duplicate the code in a TI 77c82. I've read the manual but I'm not getting what I expect. When I press the burn button (as an example) all I see on screen is 'BU' and then I cannot enter any other parameters. I was expecting to see 'BURN' and then be able to enter parameters. What, if any thing, am I doing wrong. If I put my source device into the S3 and hit Load, I see 'LO' on screen, press Enter and it appears to read the device. How do I confirm this ?
Many thanks
Chris Goddard
I'm new to the S3 via an inherited project. I need to duplicate the code in a TI 77c82. I've read the manual but I'm not getting what I expect. When I press the burn button (as an example) all I see on screen is 'BU' and then I cannot enter any other parameters. I was expecting to see 'BURN' and then be able to enter parameters. What, if any thing, am I doing wrong. If I put my source device into the S3 and hit Load, I see 'LO' on screen, press Enter and it appears to read the device. How do I confirm this ?
Many thanks
Chris Goddard