New software - Version 3.14

Software update notifications
Dataman (Daniel Smith)
Posts: 1919
Joined: 09 Nov 2011 14:36

New software - Version 3.14

Postby Dataman (Daniel Smith) » 01 May 2015 16:06

Dear Dataman users,

New software has just been posted on our software pages for the Dataman 448Pro universal gang programmer.

Version 3.14 features the following amendments:

New Device Support
Many new devices have been added in this revision, please download the full device list to verify your chip is supported: Dataman448ProDeviceList.pdf

Major Changes
Fixed "From-file playlist" serialization settings for Move/Delete used serialization files to make correct Moving/Deleting of the used files
Fixed problem with unwanted erasing of STMicroelectronics STM8S003F3U device settings after "Refind programmer" action performed
In PG4UWMC fixed weak text colors for error information of Site(s) in grid Status
On ISP Target power supply fixed problem with overcurrent error, that caused next one device operation not to switch on Target power supply voltage

Other Changes
Adapter DIL48/QFP100-1 ZIF R5F-9, Automatic YES! pins of programmer's ZIF excluded from sensing modified
Amic A29160AUV [TSOP48], power-up sequence and erase procedure modified
Atmel AT49F8011T [TSOP48], erase procedure modified
Atmel ATmega8/16 (ISP-SPI), power-up sequence modified
DIL48/TSOP56 ZIF 18.4mm NOR-4, adapter identification improved
Infineon/Siemens SAF-C508-4E/SAB-C508-4E, insertion test modified
Lattice LC4128V, pgm parameter assignment improved
Lattice LC4128V [TQFP144](SVF), improving of overcurrent protection system
Microchip PIC32MX430/450/470Fxxx, added set of configuration bit DEBUG
Micron N25Q256A81E [SO16W], power-up sequence modified
NXP LPC11Uxx, programming algorithm improved
NXP LPC1xxx (ISP-SWD), programming algorithm improved
Renesas R5F52108xxFN Boot Mode, general info modified
Semtech XE8805AMI, programming procedure improved
Spansion S25FL116K [USON8] and S25FL116K [USON8] (QuadSPI), changed device name and backward project compatibility correction
STMicroelectronics STM32, flash memory size check modified (or added if not available before)
STMicroelectronics STM32, part names refined (package type identification character added)
STMicroelectronics STM32, RPD and WRPRT bytes check before operation start modified
STMicroelectronics STM8S003F3U (ISP), load file modified
STMicroelectronics STM8S105C4T, power-up modified
TI (TMS) CC253x, programming algorithm improved
TI (TMS) CC430F5137 (ISP-4wire JTAG), entering to JTAG mode improved
TI (TMS) MSP430FRxxxx, programming algorithm modified
Winbond W25N01GVZE [WSON8], Bad Block Management Look-Up Table support added

Bug Fixes
Analog Devices ADUCM320, programming adapter name bug fixed, BGA-Top-245 ZIF-CS
Atmel ATmega164PV (ISP-SPI)(OSCCAL), EEPROM programming error bug fixed
Atmel AVR8 SPI in Enhanced mod, fixed wrong estimation of comm. speed after applying the speed-up settings
Cypress CY8C4xxx, ID check bug fixed
Freescale Semic. MKLx3Z256, programming algorithm improved
GigaDevice Semic. GD25Q256C, programming algorithm improved
Infineon TLE9832, ID check bug fixed
Lattice MachXO2, usercode bit order bug fixed (HEX, ASCII)
Microchip MCP19110/19111, identification procedure bug fixed
Microchip PIC16F1454/1455/1459, programming configuration words bug fixed
Microchip PIC16F1823(ISP)(INP-01), Communication error! bug fixed
Microchip PIC24FV, PIC24HJ, PIC32MX in DIL20 and DIL28 packages, insertion test bug fixed
Microchip PIC32MX430/450/470Fxxx, PICmicro checksum calculation bug fixed
NAND flash devices, automatic User Area - Number of Blocks recommendation fixed (had recommended higher blocks count than necessary if spare area enabled)
NXP LPC822M101J [HVQFN33], device name fixed
STMicroelectronics STM32L, flash memory programming fixed if programming should start from page 1 or higher
STMicroelectronics STM32L063R8 [LQFP64], programming adapter type and package information fixed
STMicroelectronics STM32L1xxxE, EEPROM size information fixed in Device info
STMicroelectronics STM32W, readout protection disable bug fixed (was not successful if readout and write protections were active concurrently)
TI (TMS) TIBPAL20R4-25xFN/xNL [PLCC28], pgm parameter assignment bug fixed
TI (TMS) TPS53641, verifying algorithm improved

Best regards,

Daniel Smith

Return to “Software Update Notifications”

Who is online

Users browsing this forum: No registered users and 4 guests