New here great device but...

General topics relating to Dataman that do not fit the above categories
Dataman (Neil Parker)
Posts: 931
Joined: 10 Nov 2011 09:51

Re: New here great device but...

Postby Dataman (Neil Parker) » 30 Jun 2021 09:12

Adam,

Can I ask you to check the levels of the signals according to the datasheet, Section Monitor > ROM, Monitor mode entry, PTC0, PTC1 level:

Check datasheet, Section: Monitor ROM, Monitor mode entry, PTC0, PTC1 level.
Try to isolate COM pin PTA0 using a jumper instead of a resistor.
Try DIV4 PTC3 level.
Try a slower comm speed.
Try to lower or omit the C2 capacitor in reset circuit.

If you continue to have problems then I would recommend to use off-board programming.

Best regards,


Neil Parker
Dataman Programmers


Return to “General Conversation”

Who is online

Users browsing this forum: No registered users and 9 guests