Page 1 of 1
YES-Input (ISP) via LabView Remote
Posted: 23 Dec 2016 07:10
by ProgrammerTOS
Hello,
I am controlling the Dataman 48Pro2 via Labview (remote) and I would like to know if there is a possibility to get the status of the automatic YES-Input on the ISP-Interface by using the remote-library for LabView.
Thanks a lot!
Re: YES-Input (ISP) via LabView Remote
Posted: 23 Dec 2016 10:08
by Dataman (Neil Parker)
Hello ProgrammerTOS,
Thank you for your question. Automatic YES! is only available for off-board programming. For ISP, the YES! button or YES! signal or YES! input from the keyboard is used to start the programming ... .
If you have any further questions, please contact me.
Best regards,
Neil Parker
Dataman Programmers
Re: YES-Input (ISP) via LabView Remote
Posted: 23 Dec 2016 11:23
by ProgrammerTOS
Hello Mr. Parker,
thank you very much for your answer.
So that I understand this correct, that means there is no way to get the Yes-Input-Signal from the ISP-Connector/ISP-Interface into my remote-controlling LabView program?
Best regards.
Re: YES-Input (ISP) via LabView Remote
Posted: 23 Dec 2016 16:50
by Dataman (Neil Parker)
Hello ProgrammerTOS,
The YES! signal from the ISP connector starts the programming automatically. It is not a signal that is passed to anywhere for processing.
Best regards,
Neil Parker
Dataman Programmers