NAND "update" mode or just erase part of it?
Posted: 10 Nov 2011 16:30
Im working with nand chips and i just need to replace the first few blocks. but with the programmer, i have to read it all, erase the chip, load the new first blocks then program it all back.
I want to either be able to do:
"update" mode, programmer reads the chip then just updates whats different
or
erase 0-XX blocks so i can just program those back
Bad_Ad84
I want to either be able to do:
"update" mode, programmer reads the chip then just updates whats different
or
erase 0-XX blocks so i can just program those back
Bad_Ad84