Page 1 of 1
Problem programming Scenix SX18AC
Posted: 10 Nov 2011 17:10
by Guest
I am using Dataman 48 with soft. ver. 4.4
I can´t set FUSE and FUSEX but program is ok.
Can anybody help me.
Thanks
diogo
Re: Problem programming Scenix SX18AC
Posted: 10 Nov 2011 17:10
by Dataman (Neil Parker)
Diogo....
Please download the latest software ver 4.60 from our website and give it a go, if you are still having problems then please get back to us.
Neil
Re: Problem programming Scenix SX18AC
Posted: 10 Nov 2011 17:10
by Guest
I have the same problem.
Can you help me?
A.Ruas
Re: Problem programming Scenix SX18AC
Posted: 10 Nov 2011 17:11
by Guest
I have the same problem with ver 4.60.
Can you help me?
A.Ruas
Re: Problem programming Scenix SX18AC
Posted: 10 Nov 2011 17:11
by Dataman (Neil Parker)
A.Ruas....
After you have burnt the chip you need to do memory prot/prog config under device options, this will then program any configuration set in the config options.
This should solve the problem.