Dataman Forum

Hi
I have just downloaded and installed new s/w for the 48Pro+, once I have selected a device the multi project window opens and the only way out of this window is too close which loses the device I have just selected. How can I stop the multi project window from opening and run in normal mode?

Hello PeteS,

The device you are selecting is a Multi-chip device – (memory) device with two or more independent chips (of the same or various types) in a single package.

Working with these types of device presents a problem. These multi-chip devices put specific requirements on the programming process. The programmer must be able to conduct various memory types and switch between them again and again.

We have addressed this by implementing the Multi-Project feature. Multi-Project files can include one or
more Project files for individual Sub-devices.

We have created an application note on the Multi-Project feature which can be found on our website here.

If you have any questions, please let me know.

Regards,
Neil Parker
Dataman Programmers