Dataman Forum

Hi Neil

just wondered if you could add a ST Z86E11. it programs exactly the same as the one allready in the library ST Z86E21 but I have to remember to change the eprom size from 8k (1FFF) to 4k (0FFF) every time.

might be handy to have it in there!! There is already the Zilog Z86E11 in the software but that programs differently to the ST version.

Should be a easy one to add??

Many thanks

Andrew

Hello Andrew,

The ST Z86E11 device is not supported on any of our programmers and we do not currently have any plans to add the support.

It is a very old and long obsoleted device, yours is the first such request for its support.

I will keep an eye on this thread and if there is further interest we will review the situation again.

Neil Parker
Dataman Programmers

ok thanks Neil,

I will just have to use the Z86E21 chip and change the eprom size.

I was able to easilly get hold of brand new ST Z86E11 and in quantity as well.

Pity there is not a 'custom libary' in the software where you can take a exsisting device and modify its settings and store it. I have had this before with other devices I would like to have done this with too, this is not the first.

Andrew