Program renesas mcu on board with dataman

Topics related to the Dataman 40Pro
fufufufu
Posts: 1
Joined: 07 Mar 2013 03:18

Program renesas mcu on board with dataman

Postby fufufufu » 07 Mar 2013 03:26

We want to buy a dataman programmer to program MCU uPD78F0485 on board.
As we know, there are two ways to program uPD78F0485, one is using 3 Wire serial I/O,
another is using UART6.
So, we want to know which mode dataman programmer is using. And we need to change
our hardware accordingly.

Which way dataman is using to program uPD78F0485 ? Please advice.
Or, please let me know which MCU (uPD78F0485) pins should be connected to dataman
programmer during programming.

Dataman (Neil Parker)
Posts: 931
Joined: 10 Nov 2011 09:51

Re: Program renesas mcu on board with dataman

Postby Dataman (Neil Parker) » 08 Mar 2013 16:54

Dear fufufufu,

We are able to add the ISP support for this device. Please note that we are only able to add the support to the Dataman-48Pro+ and above models. The Dataman-40Pro is not able to support this device.

We have scheduled the work in and it can be done within 3-4 weeks. I will inform you when the updated software is available.

If you have any questions, please contact me.

Best regards,

Neil Parker
Dataman Programmers

Dataman (Neil Parker)
Posts: 931
Joined: 10 Nov 2011 09:51

Re: Program renesas mcu on board with dataman

Postby Dataman (Neil Parker) » 13 May 2013 10:56

Dear fufufufu,

Apologies for the lengthy delay with this device support.

The ISP support for this device has now been implemented.

Please download, install and use latest OnDemand software:
URL: http://www.dataman.com/downloads/dl/fil ... ftware.zip
Version: 2.97p/05.2013

If you have any questions, please contact me.

Best regards,

Neil Parker
Dataman Programmers


Return to “Dataman 40Pro”

Who is online

Users browsing this forum: No registered users and 5 guests