Dataman Forum

We have recently purchased the SDP-7128-100Q adapter for the EPM7128EQI100-20 device. We have a Dataman 48LV. When using v4.67 of the software, when I select EPM7128E @100 as the device, the software says:
"This device requires an adapter that is presently not supported. Please refer to the pin-swapping tables in 'ADAPTER.TXT' if you want to construct your own adapater."
I have ignored this message but had problems with messages indicating over-current conditions during programming. I eventually was able to program a device, but the programmed devices do not drive any of the chip's outputs. Does the software really not support the adapter we bought?

Stephen Kennedy

Stephen,

Please select EMP 7128S as EPM 7128E @100 in the software.
If no ID error, this is the right selection.
If ID error occurs then change to EMP 7128E@100.
If over current, it means the chip is bad or you have inserted in wrong position.

Hope this helps.

Neil