Dataman Forum

I looking into purchasing a dataman pro48+ I'm wondering if I can use the adapters I already have?

I have a number of generic adapters (some from ET, some from others)

TSOP 32 to PDIP32
TSOP 48 to PDIP48

misc PLCC to pdip
misc soic to pdip
misc ssop to pdip

for example, Can I program a m28w320fcb TSOP48 using a simple 48pin TSOP to PDIP48 adapter or do a need a special dataman adapter?


Is there a list of pin mapping for the passive adapters so I can "buzz out" my adapters to see if they match?

Thanks,


-Techtom

Techtom,

In general, all adapters up to 48 pins are universal = wired 1:1 pin to pin.

The DIL48/TSOP48 ZIF 18.4mm is not special, it is universal, 1:1 pin to pin wired adapter.

Without knowing the exact pinouts of your adaptors it is difficult to say for sure.

Hope this helps.

Neil