Dallas DS1220 BURN hangs
Posted: 17 Mar 2021 13:08
Hello, great to see an active forum for such an old device! Lets test if it can help
I have a problem burning a Dallas DS1220 using the newest "Flash v1.14" 8_bit_flash_eeprom_nvram_library.
Steps to reproduce:
- Empty ZIF-socket (yes, it even fails without a chip!)
- Select "Dallas DS1220 (Alg 57, Ref 0700)"
- Press BURN + ENTER
The S4 now hangs at "Address 100XX".
All Datalines cycles at ~30 kHz, /WE pin is constant high.
All other Dallas devices seem to burn okay - Even without a chip inserted - The compare than fails, no wonder.
There are 5 other DIP24 SRAMs in that library that seem to use the same pinout - I have the same error on them (with and without the chip inserted).
Kind regards
Stefan
I have a problem burning a Dallas DS1220 using the newest "Flash v1.14" 8_bit_flash_eeprom_nvram_library.
Steps to reproduce:
- Empty ZIF-socket (yes, it even fails without a chip!)
- Select "Dallas DS1220 (Alg 57, Ref 0700)"
- Press BURN + ENTER
The S4 now hangs at "Address 100XX".
All Datalines cycles at ~30 kHz, /WE pin is constant high.
All other Dallas devices seem to burn okay - Even without a chip inserted - The compare than fails, no wonder.
There are 5 other DIP24 SRAMs in that library that seem to use the same pinout - I have the same error on them (with and without the chip inserted).
Kind regards
Stefan