Dataman Forum

Hello,

I can't read/erase any GAL's, specifically 20 dip, GAL16V8B H415D21 (15LP) or GAL16V8B H328D55 (25LP)

Thank you in advance.

Hello mektrix5000,

We do not currently support this GAL device on the Dataman-S6 programmer so I will ask our engineers if we can implement the programming support. As soon as I have more information I will post an update here.

Best regards,

Neil Parker
Dataman Programmers

Hello mektrix5000,

We do not currently support this GAL device on the Dataman-S6 programmer so I will ask our engineers if we can implement the programming support. As soon as I have more information I will post an update here.

Best regards,

Neil Parker
Dataman Programmers

Thanks Neil, appreciate the quick response.

Hello mektrix5000,

Our engineers have confirmed that we are able to add support for both of the mentioned devices.

GAL16V8B H415D21 (15LP)
GAL16V8B H328D55 (25LP)

Our engineers have requested samples, 1-2 pcs (non-returnable) of each device to allow us to finalise the programming support.

If you wish to proceed then please send the devices for my attention to:

Dataman Programmers Ltd
Attn: Neil Parker
Unit 2 Newton Hall
Dorchester Road
Maiden Newton
Dorset
DT2 0BD
UK
Tel: +44 (0)1300 320719

If you have any questions please do not hesitate to contact me.

Best regards,

Neil Parker
Dataman Programmers

Ah ok, didn't realize you were located in the UK. I'll get back to you if I decide to ship them, thanks Neil.

Hi Neil, can you tell me which brand/model the Dataman supports? GAL16V8D(DIP20) is in the software list already, is it the brand I chose that's incompatible? Thank you.

Hello,

The currently supported device is the Lattice GAL16V8D.

Where are you based? We have an office in Florida, USA which you can send the requested samples to.

Best regards,

Neil Parker
Dataman Programmers

I'm in the US, Florida would be great! Please forward the address information and I'll drop them in the mail. Thank you

Shipped, wanted to send you the tracking number but the forum won't allow me to send you a PM. Thanks

Please use [email protected] which will come through to me.

Best regards,

Neil Parker
Dataman Programmers