Dataman Forum

I have an S3 plus EPLD1 and EPLD2 modules plus 1.1 and 1.4 firmware.

As far as I can see there is a version of the S4 firmware (1.57) that adds support for Lattice GALs as well as ATMEL ATF GALs to the existing support for Altera EP300..320 and Cypress PALC 16, 20, and 22 devices on the EPLD1 module.

Will this work on the S3?

What do I need to do to extract the algorithms and details from it to program GALs on an S3?


Thanks

Peter

Peter,

As I said in response to your other post, the S3 is now over 30 years old, all information that we have been able to round up is available on our website. If there was anything else then it has been lost I am afraid. There are no longer any staff working at Dataman that have first hand knowledge/experience with the S3 programmer. Sorry I don't have better news.

Best regards,


Neil Parker
Dataman Programmers