S4 receive library
Posted: 22 Jan 2023 11:22
I want to use the 'load library from PC' function, FUNC RCVE, invoking it on the S4 and manually sending the file.
When I run it, I get a messages RESTRICT LOAD ON and prompts
NO LOAD > FFFFFF
NO LOAD < 000000
I can only change the first 2 digits of these values.
These aren't described in the S4 manual (at least as far as I can find). What does it do ? I thought it might
automate the task of removing data between F800-FFFF but the ability to change only the first 2 digits makes
this impossible.
So far, my efforts to change the library this way have failed - the transfer proceeds normally but after resetting I
still have the earlier library loaded (eprom 3.00).
When I run it, I get a messages RESTRICT LOAD ON and prompts
NO LOAD > FFFFFF
NO LOAD < 000000
I can only change the first 2 digits of these values.
These aren't described in the S4 manual (at least as far as I can find). What does it do ? I thought it might
automate the task of removing data between F800-FFFF but the ability to change only the first 2 digits makes
this impossible.
So far, my efforts to change the library this way have failed - the transfer proceeds normally but after resetting I
still have the earlier library loaded (eprom 3.00).