Hi,
I'm trying to program AT45DB011B throught 48PRO2 programmer but got veryfing issue.
I'm using SOIC8 and use a SOIC to ZIF convertor.
I load data to write in buffer then click on program. The programation is ok but I got problem during verifying. Some data in FLASH are different compared to buffer (around 45 bytes).
Am I doing something wrong? Could you help me?
Thank you,
Regards,
AT45DB011B
-
- Posts: 931
- Joined: 10 Nov 2011 09:51
Re: AT45DB011B
Hello Chris,
Did you see the information we provide in the software under the "Device info" section for this device?
General Info:
In case of unreliable work with this device connect 22nF-100nF multilayer capacitor (that meets the EIA X7R or Z5U specification) between VCC and GND pins.
Pins assignment:
VCC = 6
GND = 7
Please apply the bypass capacitor to the adaptor and let me know if the situation does not improve.
Best regards,
Neil Parker
Dataman Programmers
Did you see the information we provide in the software under the "Device info" section for this device?
General Info:
In case of unreliable work with this device connect 22nF-100nF multilayer capacitor (that meets the EIA X7R or Z5U specification) between VCC and GND pins.
Pins assignment:
VCC = 6
GND = 7
Please apply the bypass capacitor to the adaptor and let me know if the situation does not improve.
Best regards,
Neil Parker
Dataman Programmers
Re: AT45DB011B
Hi Neil,
It works perfectly. Really thank you .
Regards,
It works perfectly. Really thank you .
Regards,
Return to “Devices and Programming”
Who is online
Users browsing this forum: No registered users and 20 guests