New software - Version 3.98

[Dataman (Daniel Smith)]

Dear Dataman users,

New software has just been posted on our software pages for the Dataman 48Pro2C super fast universal ISP programmer.

Version 3.98 features the following amendments:

New Device Support
Many new devices have been added in this revision, please download the full device list to verify your chip is supported: Dataman48Pro2CDeviceList.pdf

Major Changes
Job Report added new checksums information, e.g. Multi-project checksum, MD5
Fixed loading multi-project file during PG4UWMC startup

Other Changes
Added adapter: BGA-Bottom-536
Added adapter: BGA-Bottom-541
Added adapter: DIL48/BGA99-1 ZIF LT-1
Added adapter: DIL48/QFN56 ZIF MP-1
Added adapter: DIL8/BGA8-3 ZIF-CS
Added configurable additional after-reset-delay for some of HCS12 ISP devices
Cypress CY27410F, programming procedure improvement
Cypress/Infineon/Spansion S6E2Cx/S6E2Gx, read operation improved
Geehy APM32A103, APM32E103, APM32F103, APM32F105 and APM32F107, added check for successful activation of readout protection (READPROT)
Infineon TLD7002-16ES [TSDSO24], programming procedure improved
Renesas R5F566Txxxxx, serial boot mode access, added option for setting endian of programmed data

Bug Fixes
eMMC devices, 'Set User Area end parameter according to the size of the recently loaded binary file procedure' bug fixed
Lapis ML62Q1xxx, Program/Verify operation bug fixed
NXP LPC1768 (ISP-SWD), power supply voltage test bug fixed
SkyHigh S34ML04G300Bxx10 [BGA63] (AML-03), Target device state selection warning message fixed

Best regards,

Daniel Smith