New software - Version 3.99
Posted: 10 Jan 2025 10:53
Dear Dataman users,
New software has just been posted on our software pages for the Dataman MEMPro universal memory programmer.
Version 3.99 features the following amendments:
New Device Support
Many new devices have been added in this revision, please download the full device list to verify your chip is supported: DatamanMEMProDeviceList.pdf
Major Changes
Other Changes
Atmel ATmega168PB [MLF32](OSCCAL@5V), ATmega328PB [MLF32](OSCCAL@5V), Added warning during verification if calibration selected
Atmel/Microchip ATmega168PB [VQFN32](OSCCAL@5V), ATmega328PB [VQFN32](OSCCAL@5V), Added warning during verification if calibration selected
Azoteq IQS227B, IQS227D, added support of programming ENS bit
NAND flash devices, added Unique ID read (actually for selected devices only)
Bug Fixes
Best regards,
Daniel Smith
New software has just been posted on our software pages for the Dataman MEMPro universal memory programmer.
Version 3.99 features the following amendments:
New Device Support
Many new devices have been added in this revision, please download the full device list to verify your chip is supported: DatamanMEMProDeviceList.pdf
Major Changes
Other Changes
Atmel ATmega168PB [MLF32](OSCCAL@5V), ATmega328PB [MLF32](OSCCAL@5V), Added warning during verification if calibration selected
Atmel/Microchip ATmega168PB [VQFN32](OSCCAL@5V), ATmega328PB [VQFN32](OSCCAL@5V), Added warning during verification if calibration selected
Azoteq IQS227B, IQS227D, added support of programming ENS bit
NAND flash devices, added Unique ID read (actually for selected devices only)
Bug Fixes
Best regards,
Daniel Smith