Creating a project file from command line
Posted: 23 May 2025 11:05
I have been able, using pg4uwcmd to open Dataman in demo mode, open a project and load a .mot file which is great. I can also see how to save a new project file from this. I need to perform one step on the .mot file before saving the project -
Within the tool it would be Buffer->Copy block... Then from the popup setting a start, end and destination address
Is it possible to replicate this step from the command line, or will I have to use the libraries and go down for example the .Net route (is that even possible)
Many thanks in advance
Brian
Within the tool it would be Buffer->Copy block... Then from the popup setting a start, end and destination address
Is it possible to replicate this step from the command line, or will I have to use the libraries and go down for example the .Net route (is that even possible)
Many thanks in advance
Brian