Dataman Forum

Hi there,

I have a Dataman S4 and need to program some Atmel ATF16V8 / ATF22V10 GAL's.
According to the device list, this requires the GAL Module - does anyone have details on this? Is it a simple passive adaptor or active?

Thanks,

Hello marklamond,

Unfortunately we no longer have any of the S4 GAL modules available to sell.

They are not simple pin swap modules otherwise we would make the details available.
The Atmel ATF16V8 / ATF22V10 GAL's are supported on the Dataman-48Pro2C if you need a solution.